Page 11
Figure 8
3.
Loosen the star knob screws marked
in Figure 8 and fasten them on the
marked position.
4.
Pull the seeding shaft out of the
metering unit in the direction shown by
the arrow (Figure 8).
5.
To install the seeding shaft, proceed in
the reverse sequence.
Agitator
Use of the agitator is only required for spreading materials that tend towards bridging.
If the agitator is not needed, then proceed as follows:
1.
To remove the motor cover, remove the 6 bolts marked in Figure 9, Figure 10 and Figure 11
Figure 9
(WAF 10).
Figure 9: Removing the 3 bolts
Figure 10: Removing the 2 bolts
Summary of Contents for UD 100 M1
Page 20: ...Page 20 10 Connection diagram Figure 23...
Page 27: ...Page 27 Notes...
