Page 6
Figure 2
Mounting the control box
Fasten the standard supplied bracket with two bolts in
the tractor cab. Stow the excess cable in the driver's cab
to avoid pinching.
CAUTION!
If possible, do not roll up the cable into a coil!
On the bottom side of the control box, there is a 3-pin
plug (= connection to the power supply of the tractor),
a 6-pin plug (= connection of the spreader to the
control box), and a 12-pin plug for the sensors (speed
sensor and/or lifting unit sensor).
TIP!
Pay attention to the angle at which you
look at the control box to be able to read
the display optimally. If necessary, bend
the bracket slightly to adjust the angle as
required.
The standard supplied cable can be directly
connected to the 3-pin standard socket of the tractor
in the cab. The other end is connected to the control
box.
If your tractor does not have a standard socket, it can
be retrofitted with the cable set included with the
accessories.
The fuse (30 A) is located on the right side of the
control box.
Figure 3
Summary of Contents for UD 100 M1
Page 20: ...Page 20 10 Connection diagram Figure 23...
Page 27: ...Page 27 Notes...
