Page 7
CAUTION!
The 12 volt power supply must NOT be connected to the socket for the cigarette lighter.
After use of the implement, the control box should be disconnected again (for various
safety-related reasons).
If your battery is charged by a charger that is in "Start" operating mode, there can be
voltage peaks! These can cause damage to the electrical system of the control box if it is
also connected when the battery is being charged.
CAUTION!
If these instructions are not observed, damage may be caused to the control box.
CAUTION!
After using the implement and for road transport, the control box must be switched off
again (for various safety-related reasons).
5
Settings and operation
Spreading width
The spreading width depends on the density of the de-icing product/salt/grit, on the delivery rate of the
seeding shaft, and the speed of the spreading disc. The snow and ice removal machine is designed
such that it can spread the spreading material evenly across a spreading width of approx. 6 m. The
precise settings for the spread rate, working width etc. can be taken from the setting chart (point 5.2).
We recommend that the spreader be mounted at least 1 m above the ground to achieve a certain degree
of spreading density.
CAUTION!
Make sure that the salt or de-icing product is STORED IN A DRY PLACE, otherwise it can
form clumps in the hopper!
It flows optimally with fine and completely dry salt quality.
Summary of Contents for UD 100 M1
Page 20: ...Page 20 10 Connection diagram Figure 23...
Page 27: ...Page 27 Notes...
