22
Ensure that the stop tap (if present) is closed and that the securing chains are hooked in.
Also ensure that securing cotter pins have not been lost due to work implementation.
Only dissipate the pressure of the hydraulic hose at home, via the float position on the tractor control
unit.
The holder for the warning signs (supplemental equipment) is mounted on the carrier of the support
foot.
When driving on roads after field operation, the implement should be cleaned of field residues (soil,
grass, etc.).
12.2
CALCULATION OF THE WEIGHT RATIOS OF AXLE LOADS ON
THE TRACTOR UNIT AND BALLAST WEIGHTS
If you want to drive with an implement that is attached to the 3-point linkage, you must ensure that you do
not exceed the tractor's permissible axle loads and tire load capacities with the mounted implement.
The front axle of the tractor must be loaded with at least 20% of the net weight of the tractor.
All of these values can be determined with this calculation:
Figure 20
Information:
T
L
Unladen weight of the tractor
T
V
Front axle weight of the unladen tractor
T
H
Rear axle load of the unladen tractor
G
H
Total weight of the rear-mounted
implement
G
V
Total weight of the front-mounted
implement
a
Distance from the front-mounted
implement's center of gravity to mid
front axle
b
Wheelbase of the tractor
c
Distance from the middle of the rear
axle to the center of the lower link ball
d
Distance from the center of the lower
link ball to the center of gravity of the
rear-mounted implement
(d
= 97 cm)
WEIGHT CALCULATIONS
1.
Calculating the minimum front ballasting on rear-mounted implements G
V
min:
Enter this result in the table under point 12.3.
2.
Calculating the minimum rear ballasting on front-mounted implements GH min:
Enter this result in the table under Point 12.3 as well.
Summary of Contents for RH 600 M1
Page 30: ...30 NOTES...
Page 31: ...31 NOTES...
