APV RH 600 M1, Operating Manual

Page: 10 / 32

10

Disconnect the cables on the generator and battery when performing electrical welding tasks on the
tractor and attached implements! The repair points must be cleaned (risk of ignition if there is fouling)!

Spare parts must at least meet the technical requirements specified by the implement manufacturer!
Original parts meet these requirements!

Only universal joint shafts prescribed by the manufacturer can be used!

The guard tube and guard funnel for the universal joint shafts as well as the PTO shaft guard
– also
on the implement side
– must be installed and they must be in proper condition!

For universal joint shafts, pay attention to the prescribed tube covers in transport position and working
position!

The universal joint shaft must only be mounted and dismounted when the PTO shaft and the motor
are switched off and the ignition key is removed!

Always ensure that the universal joint shaft is properly mounted and secured!

Prevent the universal joint shaft guard from rotating simultaneously with the shaft by hooking in the
chain!

Before switching on the PTO shaft, ensure that the selected PTO shaft speed of the tractor matches
the permissible speed of the implement!

When using the ground speed PTO, ensure that the rpm is forward speed-dependent and that the
direction of rotation is inverted when driving in reverse!

Before switching on the PTO shaft, ensure that no one is standing in the danger zone of the implement!

Never switch on the PTO shaft when the motor is switched off!

When working on the PTO shaft, ensure that no one is standing in the area of the rotating PTO shaft
or universal joint shaft!

Always switch off the PTO shaft if excessive angular deflection occurs and it is not required!

Caution is required after switching off the PTO shaft: Danger due to the centrifugal mass that is still
rotating!

Do not get too close to the implement during this time. Work can only be performed after it comes to
a complete standstill!

Cleaning, lubricating or adjusting the implement or universal joint shaft driven by the PTO shaft must
only be performed when the PTO shaft and motor are switched off and the ignition key is removed!

Place the uncoupled universal joint shaft on the prescribed holder!

After dismounting the universal joint shaft, fit the protective cover onto the PTO stub!

If damaged, it must be replaced immediately before working with the implement!

If necessary, use additional lighting (e.g. hand lamp) for repair or maintenance tasks.

The implements should be regularly lubricated and cleaned (outdoors) using water or compressed air.
While doing this, personal protective equipment must be worn if necessary.

Maintenance and cleaning tasks must be carried out with the implement lowered, engine switched off,
and secured to prevent it from being switched on again.

We recommend a cleaning in accordance with the maintenance instructions. In this regard you must
proceed as specified in the maintenance manual and protective equipment must be used. The Rotary
Hoe must be cleaned with water (no high-pressure cleaner) or compressed air.
5.6 TIRES

For tasks on tires, ensure that the implement has been safely parked and secured against rolling off
(wheel chocks).

Installing wheels and tires requires adequate knowledge and the prescribed installation tools!

Repair tasks on the tires must only be performed by specialists and with the appropriate assembly
tool!

Regularly check the tire pressure! Pay attention to the prescribed air pressure!
5.7 ATTACHED SEEDERS

When using a seeder, all the instructions provided by the implement manufacturer must be complied
with.