APS CFS108, Operation Manual

Page: 87 / 146

CFS100 SERIES OPERATION MANUAL
SECTION 6: FRONT PANEL OPERATION
Entire Contents Copyright

2016 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CFS100 Series Power Source Operation Manual Page 87 of 146
6.12.8 User Prompt Programming
A user prompt of up to 32 characters in length can be displayed at the start of each test. The
operator has to press the Enter soft key to acknowledge the on screen prompt pop-up
before the actual test starts.
To program the Prompt Message, use the “
∧ and ∨ ” soft keys to navigate to the Prompt
parameter. Pressing the “ Edit ” soft key will display the screen shown below.
Entering a prompt is accomplished in the same way as entering a test program name as
described in Section 6.11.2, “Assigning a Name to a Memory Location” using both the
character map for characters and the numeric keypad for numbers.
To save the prompt message press the “
<more> ” soft key which will bring you to the
following screen.
Press the “ Enter ” soft key to accept the prompt message. To cancel the prompt message,
press the “ Esc ” soft key. When the “ Enter ” soft key is pressed, the prompt is accepted and
the next parameter screen (Step Cycle) is displayed.
Note: The user can bypass editing this parameter and move to the next or previous
parameter set screen by pressing the “
Prev
” or “
Next
” soft key.