CFS100 SERIES OPERATION MANUAL
SECTION 5: UNPACKING & INSTALLATION
Entire Contents Copyright
2016 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CFS100 Series Power Source Operation Manual
Page 49 of 146
5.11
Rear Panel Controls and Connectors
All CFS100 Series have several controls and connectors on the rear panel in addition to the
AC input and AC output terminals covered in the previous sections. Other connectors and
features are detailed in this section by model number.
5.11.1
CFS108 Rear Panel Overview
The callouts for the controls and connectors located on the rear panel of the CFS108 are
identified in the table below.
Figure 5-11: CFS108 Rear Panel Callouts
Callout
Description
1
AC and DC Terminal Block
2, 11
Cooling Fan Exhausts. Must be kept clear at all times.
3
Remote Output Connector DB9. Provides contact closure outputs for the
following power source conditions:
•
Test in Progress
•
PASS
•
FAIL
4
SYNC Output BNC. TTL Output signal that indicates output zero crossing when in
AC or PROGRAM mode. May be used to synchronize other test equipment.
5, 6
USB/RS232 Interface Card. For models with LAN option, this location contains
USB and LAN connector Card instead.
7
IEC320 Type AC Line Cord Mating Connector. Check AC input voltage setting
switch (8) before applying input power.
8
AC input voltage selector switch. AC line input voltage setting is determined by
the position of this switch.
Note: Do not change switch position while AC input power is applied. Always
disconnect AC line cord first. Use small flat blade screwdriver to change setting.
9
Earth Ground Connector. Additional ground connection to AC line cord ground.
10
AC Input Line fuse holder. Model CFS108 requires 250V, 15A protective fuse.
Spare fuse included in ship kit. (See Section 5.3.1, “CFS108 Ship Kit Contents”).
To change fuse, disconnect AC line cord first, then turn fuse holder counter
clockwise to open.
Summary of Contents for CFS108
Page 145: ......
