DPS SERIES OPERATION MANUAL
SECTION 3: PRODUCT OVERVIEW
Entire Contents Copyright
2016 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CFS100 Series Power Source Operation Manual
Page 15 of 146
3.1.3
Model CFS140
This CFS140 offers 4000VA output in AC mode and 2000W output in DC mode. It is similar in
width to the CFS108 and CFS140 but much taller and heavier. A rack handle kit for
installation in a 19” cabinet is included but additional L-bracket support is required to install
into a cabinet due to the unit’s weight.
The CFS140 requires too much AC input current to use a modular power cord. Instead, it is
equipped with an AC line disconnect circuit breaker and an AC input terminal strip. Both are
located on the rear panel. Refer to Section 5, “Unpacking and Installation”
3.2
Product Features
The following key characteristics apply to all CFS100 Series models;
•
Fully programmable AC and DC output modes
•
Frequency range in AC mode is 40 Hz to 500 Hz
•
Dual voltage ranges in both modes
•
AC voltage ranges are 5-150Vac and 5-300Vac RMS
•
DC voltage ranges are 5-200Vdc and 5-400Vdc.
•
Programmable Current limit with Fold-Back (CC) and Shutoff Modes (CV)
•
Full complement of output parameter metering:
o
Frequency
o
Volt AC or DC
o
Current AC or DC
o
AC Peak Current
o
Current Crest Factor
o
True Power
o
Apparent Power
o
Power Factor
•
Over voltage, over current, over power and over temperature protection
•
Fan Cooled
•
USB and RS232 remote control interfaces
•
Remote Interlock
Summary of Contents for CFS108
Page 145: ......
