CFS100 SERIES OPERATION MANUAL
SECTION 6: FRONT PANEL OPERATION
Entire Contents Copyright
2016 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CFS100 Series Power Source Operation Manual
Page 68 of 146
programmed testing parameters. If a PASS result occurs for the step, the operator can
proceed to the next step in the sequence. If a FAIL result occurs for the step, the
operator will not be able to proceed in the test sequence. He will have to restart from
the beginning of the test sequence or step number one.
When the
Single Step
mode is
OFF
, the source will automatically sequence from one
step the next regardless if a pass or failure has occurred for a particular step.
6.10.4
Alarm Settings
Press the “
Enter
” soft key to confirm you selection. This brings up the Alarm parameter
setup screen. The Alarm parameter indicates the volume of the Alarm signal. Use the
numeric key pad to enter a value from 0 to 9 with 0 being OFF and 9 being loudest.
6.10.5
LCD Contrast
Press the “
Next
” soft key to advance to the next parameter, the LCD contrast setting.
Use the numeric key pad to enter a value from 1 to 9 with 1 being the lowest contrast level
and 9 the highest.
Summary of Contents for CFS108
Page 145: ......
