APRILIA RSV 1000 R, Workshop Manual

Page: 63 / 308

GENERAL TECHNICAL INFORMATION
2 - 31
RSV 1000 R - RSV 1000 R FACTORY
RED LINE ADJUSTMENT (ONLY WITH ENGINE OFF)
When the engine rpm exceeds the red line setting, the red
line indicator (2) on the dashboard flashes.
IMPORTANT The red line setting can only be adjusted with
the engine off and the odometer displayed (adjustment range
2000 to 12000 rpm).
The default value is 6000 rpm.
To display the red line setting, hold down TRIP/V for at least
3 seconds. The revolution counter pointer (1) will move to the
set red line value.
To adjust :
• Turn the ignition key to “ ”.
•
Wait for the self-check to complete.
•
Press TRIP/V for more than 3 seconds: the revolution
counter pointer (1) will move to the set red line value.
• The red line setting can be adjusted during the 3 sec-
onds that the revolution counter pointer (1) is indicating
the set value.
•
Adjust the red line setting with the + key: pressing it
briefly will increase the setting by 100 rpm; holding it
down will increase it by 1000 rpm.
•
If the pointer reaches the full-scale value (12000 rpm) it
is automatically reset to zero.
•
3 seconds after the last adjustment (+ key) the new red
line setting is stored and confirmed by the red line indi-
cator (2) turning on for 3 seconds. The pointer (1) re-
turns to zero.
• If the engine is started during the adjustment proce-
dure, the previous setting is maintained. The setting is
lost if the battery is disconnected during the adjustment
procedure, and the previous setting is maintained.
DASHBOARD ECU DIAGNOSTICS CODE DISPLAY
Display type :
water temperature digits together with EFI icon and warning
led ( ). When a diagnostics code is displayed, the water
temperature’s symbol (thermometer), units’ indication (°C/°F)
and display segments disappear.
Operating modes :
In normal conditions, the “
EFI ” icon and warning led ( ) are
off. If one or more Fault Codes are sent to the dashboard by
the ECU, the dashboard will not display them; it will only turn
on the warning led ( ) and “
EFI ” icon instead.