APRILIA RSV 1000 R, Workshop Manual

Page: 19 / 308

GENERAL INFORMATION
1 - 12
RSV 1000 R - RSV 1000 R FACTORY
1.4. RUNNING-IN
1.4.1. RUNNING-IN RECOMMENDATIONS
Running-in the engine is essential to ensure its duration and correct functioning.
If possible, drive on hilly roads and/or roads with many bends, so that the engine, the suspensions and the brakes un-
dergo a more effective running-in.
During the running-in, change speed.
In this way the components are first "loaded" and then "relieved" and the engine’s parts can thus cool down.
Even if it is important to stress the engine components during running-in, take care not to over do it.
WARNING
You can expect the best performance levels from the vehicle only after the first 932 mi (1500 km) of run-
ning-in.
Keep to the following indications:
•
Do not open the throttle completely if the speed is low, both during and after the running-in.
•
During the first 62 mi (100 km) pull the brakes with caution, avoiding sharp and prolonged braking. This ensures a
correct bedding-in of the pads on the brake disc.
• During the first 621 mi (1000 km) never exceed 6000 rpm (see table).
WARNING
After the first 621 mi (1000 km), Dealers carry out the checks indicated in the column "After running-
in", see (REGULAR SERVICE INTERVALS CHART), in order to avoid hurting yourself or other people
and/or damaging the vehicle.
• Between the first 621 mi (1000 km) and 932 mi (1500 km) drive more briskly, change speed and use the maximum
acceleration only for a few seconds, in order to ensure better coupling of the components; never exceed 7500 rpm
(see table).
•
After the first 932 mi (1500 km) you can expect better performance from the engine, however, without exceeding
the maximum allowed [11000 rpm].
Engine maximum rpm recommended
Mileage mi (Km)
rpm
0÷621 (1000 ) 6000
621÷932 (1000÷1500 ) 7500
Over 932 (1500) 11000