APACHE-E SWIFT/LOGO10 PAGE # 19
DAWSON’S
APPROACH E GI EERI G
AH-64A ELECTRIC
15.7
Cut two pieces of ½” leading edge stock to fit the lead-
ing edge of the horizontal fin. Glue the leading edge stock cen-
tered on the leading edge with CA+. After finished sand the
leading edge to a rounded finished shape.
15.8
Viewing the horizontal fin from the bottom punch out the
1/16” balsa horizontal fin center, HFC. This will fit in the cen-
ter trailing edge of the fin. Note: The HFC will be installed at a
angle therefore it is recommended to sand the upper and lower
sheet surfaces at the same angle to create a flat surface for the
HFC to be glued. When satisfied glue the HFC in place and
sand the edges flush with the upper and lower sheeting.
15.9
Working on the horizontal fin tips, punch out the two ¼”
balsa pieces HFT. Glue on the fin tips making sure they are
centered on wing tip. Note, the horizontal fin tips are purposely
made larger to allow for sanding flush with the surfaces. When
complete sand the upper and lower surfaces flush with the
sheeting and leading edge.
15.10
Sand the horizontal fin tips to a rounded finished shape
using the pictures as a guide.
15.11
Pull out the two 1/4” by ¼” long brass tubes. Punch
out the two lower horizontal fin supports HFS-2 from the ¼”
light ply sheet. Roughen up the outside surface of the brass
tubes with sandpaper. Glue the brass tubes into the half circle
in the lower fin supports. Put into place and drill and counter-
sink the holes. Temporarily install the screws to check the fit.
15.12
Depending on your scale options you may finish the
horizontal fin to be rotated by a servo. With the use of a scrap
piece of light ply and a control horn you may control the fin
with a spare channel.
15.0 HORIZO TAL FI
ASSEMBLY
HFT
Summary of Contents for AH-64A APACHE SWIFT/LOGO 10
