Chapter 5: APEC Network Operation
81
Fig. 5-13
5.6.3 Alarm & remote control
The GPI state can be NO(normally open) or NC(normally close). When NO is selected as shown
below, AP-5004 generate alarm if the GPI state changes to “close” by external event. There are maximum
8 GPI and GPO points in a AP-5004 depends on the IO device installed. The state of GPO can be “ON”
or “OFF” . When “OFF” is selected as below, it means the output points are “open” and when “ON”, it
means “close”.
Fig. 5-14
5.6.4 System configuration
Use the
System Configuration
page to set the following parameters for the AP-5004.
• Running mode
– Select
“Network Mode
” if AP-5004 is connected to local LAN through its RJ-45
LAN port. Select “
ISP Mode
”, if it is connected to Internet via dial up telephone.
• TCP/IP setting
– This is normally for “
Network Mode
” only because when
“ISP Mode
”, the IP, DNS,
Gateway and Subnet Mask are all assigned by Internet Service Provider.
• ISP setting
– Fill in for dial-up connection to Internet through telephone line.
click to make the changes into effect
