User’s Manual Version 1.
4
Serial to Ethernet Device Server
STE-501C
Copyright © 201
7
Antaira Technologies, LLC
All rights reserved.
27
Figure 3.24 Com 1 setup –UDP mode
1.
Click on “
Save Configuration
” to save the changes.
2.
If the update is successful, the following screen appears.( Figure 3.25)
Figure 3.25 Configure success
3.4 Assign a New IP Address by ARP Command
Use ARP command to assign a static IP address of STE-501C using its hardware MAC address. The
MAC address is printed on the rear side of device in the format of "0060E9-xxxxxx". The following
example shows how it works within MS-DOS command prompt window.
(For example change IP from 10.0.50.100 to 10.0.50.101,and the MAC address of STE-501C is
00-60-e9-11-11-01)
Step1:
Add the new host IP to ARP table
->Open Ms-DOS command prompt window
->Input
arp -s 10.0.50.101 00-60-E9-11-11-01
(Figure 3.26)
Figure 3.26. Ms-DOS command prompt window
Step2:
Change to new IP via telnet port 1 (Figure 3.27)
->Input
telnet 10.0.50.101 1
Note:
The telnet will be fail and STE-501C will be restarted automatically, after restart the IP address
should be change to 10.0.50.101
Step3:
Using new IP to configure STE-501C via telnet
->Input
telnet 10.0.50.101
Note
1: When using this method to change IP address, PC's IP address and STE-501C 's IP address must
belong to the same subnet.
