ComBi
line
05/04
57
6.1
Brewing coffee
1.
Switch on the appliance by putting the ON/OFF switch
(fig. 1-2) in position I, the display (fig. 7A) lights up and
you will hear a beeping sound (1x short). Then the
display indicates the standard brewing amounts.
2.
Select one of the four brewing amounts.
3.
The selected brewing amount including a recommended
coffee dosage appears in the display (fig. 7B).
Tip: If you do not want the selected brewing amount,
you can increase/decrease it with the + or - button.
The recommended coffee dosage changes accordingly.
4.
Place a basket filter paper in the basket filter and fill it
with the recommended brewing amount of coffee
(standard ground). Spread the coffee evenly in the filter
and then put the filter lid on.
5.
Place the filter unit on the container and position the
swivel arm above the centre of the filter.
6.
Press the START button (fig. 1-5.7 to start the brewing
process. In the display (fig. 7C) appears the text:
Processing
. The container heating switches on
automatically, the heating should be switched off
manually (fig. 1-5.9) if the container is empty.
During the coffee brewing process, the display shows
the selected brewing amount (fig. 7C below) and the
amount of water already gone through the filter (fig. 7C
above).
7.
When the water supply stops coming out of the swivel
arm you will hear a beeping sound (1x short). In the
display (fig. 7D) appears the text:
Leaking out
. The leak
out time is set as standard to approx. 5 minutes, and its
ending is indicated by a beeping sound (3x short).
8.
Remove the synthetic filter after it has been used and
put the insulated lid on the container.
9.
Clean the synthetic filter.
After the brewing process you can draw off a cup of coffee by
using the no-drip tap on the container.
Tip:
-
If the swivel arm and/or the container are moved out of
position before and/or during the brewing process, the
brewing process will stop, a swivel arm and/or container
symbol will appear in the display and you will hear a
beeping signal (2x short). Once the positioning fault has
been resolved the brewing process can be restored by
pressing the START button. See 5.3 overview error
reporting symbols.
-
The brewing process can be interrupted at any moment
with the STOP button (fig. 1-5.1).
The brewing process should then be considered as lost.
-
Prepare another brewing process by getting the second
synthetic filter ready if required. Once the water supply
has stopped coming from the swivel arm, you can
position the swivel arm above the other filter and start a
new brewing process immediately. The dripping symbol
from the 1st container will then disappear.
Brewing coffee
Fig. 7
