18B.
For current Sure screens (chips/switch on back side) and short ribbon
cable:
Locate the screen with the connected ribbon cable. Connect the loose
end of the ribbon cable to the PCB, ensuring the bump on the black connector is
aligned with the HDR2 text on the PCB. In this orientation, the red edge of the
ribbon cable will be closest to the prototyping area.
19. Place the screen on top of the “D” spacers and screws, ensuring the button
wires are routed through the sides (as opposed to the bottom) of the screen.
Route/place the ribbon cable such that it does not block the power jack (CN1).
35
Place the screen
on top of the
spacers; note, the
wires are routed
through the sides
(not bottom) of the
screen
Connect the loose
end of the ribbon
cable to the PCB,
ensuring the bump
on the black
connector is
aligned with the
HDR2 text on the
PCB. Note, the red
edge
of the ribbon
cable should be
closest to the
prototyping
area
