All parts sit on the top of the board and are soldered from the bottom.
Please refer to the bill of materials (BOM):
www.aomalley.org/dotklok/files/DOTKLOK_bom_illustrated.pdf
for an illustrated parts list.
Take care when unpacking the kit components, there are several small parts,
and no extras have been provided.
TIP:
the foam housing for the LED screen
makes for a handy parts tray while assembling DOTKLOK.
If your PCB is labeled “DOTKLOK 1.1” you will need to solder a wire
across the JP1 pads in order for the board to work with the power supply
included with your kit. Although a specific wire has not been included for
soldering this jumper, you can can use one of the cut-off leads from a
resistor or capacitor soldered in the following steps.
2
Solder a wire
across JP1
