9. From the test side of the front panel (marked with DOTKLOK text), insert each
button with the 8” wire into the right-side holes labeled “B”. Then, flip the panel
over to the backside (so you no longer see the text) and secure the buttons with
the black, plastic nut by placing the serrated edge of the nut against the acrylic
panel. Hand tightening is sufficient.
10. Find the two buttons with 7” wires and repeat steps #8 and #9, by
removing move the black plastic nut from each button, inserting each button
into the LEFT holes labeled “B”, then, securing the buttons with the black, plastic
nut by placing the serrated edge of the nut against the acrylic panel.
11. Arrange the top and bottom panels so they are placed beside each other.
Such that the top of each panel faces out; the buttons with the longer (8”) wires
are at the top of the photo below:
12. Connect the B2 wires (no polarity) to the next two openings (closest to the
left, right beside the B5 connections) in the green screw terminal connector
(X1). Tighten the connector screws with a screw driver and make sure the
31
Insert each button
(from the front of
the panel) into the
right-side holes
labeled “B” then
secure the buttons
by re-fastening the
black plastic nut
Place the panels
beside each other.
so the top of each
panel faces out, as
shown
