Sub MkIIIF
User Manual
Int. Approved
Document ref: ASF3-800-08
November 2018
Page 51 of 79
Copyright © 2009 Analox Ltd. All Rights Reserved.
Commercial in Confidence
Key
Function
Comment
F1
Date and Time
Adjust date and time
F2
RS232 Log On/Off
Used to toggle RS232 data output on and off
F3
Log Settings
Used to define interval between each set of readings for
RS232 output
F4
More
F1 Test
Hardware Test Function
F2 Enable Location Allows sensor module to be enabled (normal operating
mode)
F3 Disable Location Allows a sensor to be disabled (perhaps when it is faulty
or returned for repair)
F4 Top
F5 Back
Go back to previous menu (SETUP)
F5
Back
Go back to top main menu
8.2.1
Date and Time Entry
Initially, the current date and time will be displayed above the function key legends. The day field
will be highlighted. Use the NEXT key to move the highlight through each of the fields: day,
month, year, hour, minute and second. To adjust the highlighted field, press either UP or DOWN.
When the correct date and time has been obtained on the screen, press SET to set the on-board
clock with the correct date and time.
Note that the year can only be adjusted in the range 2000-2099. The days can only be adjusted
within the range for the month shown. If the days have been adjusted to 31, and the month is
changed from March back to February, the 31 Feb will appear as the date. However, if SET is
pressed, it will register as an invalid date. Similarly 29 Feb can be selected via the Up/Down keys,
but if the year is not a leap year, then pressing SET will also register as an invalid date.
The date and time setting is not critical to operation of the system. The time is shown in the top
left hand corner of the screen for convenience only, and as an indication that the system is
running. The date is used for data output time stamping. On board batteries maintain the time
whilst the system is switched off.
Summary of Contents for Sub Mk III F
Page 2: ......
