Analog way Aquilon C, User Manual

Page: 41 / 94

www.analogway.com 41
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
USER MANUAL
Output capacity – The 4-4 rule
A LivePremier unit is equipped with one, two or three Video Processing cards (VPU).
Output resources are impacted by format (resolution and rate). LivePremier units have a limited number of
Program outputs depending on the capacity set for these outputs.
Tip: - One VPU supports 4x capacity 2 program outputs AND 4x capacity 2 mixing layers
- The remaining outputs that are not used as Program can be used as Aux.
Aquilon Models RS alpha RS1 RS2 RS3 RS4 C C+
VPUs 1 1 2 2 3 up to 2 up to 3
Output connectors 4 8 12 12 16 up to 16 up to 20
Max 4K60 PGM outputs
(capacity 2)
4 Screens
+ 0 Aux
4 Screens
+ 4 Aux
8 Screens
+ 4 Aux
8 Screens
+ 4 Aux
12 Screens
+ 4 Aux
8 Screens
+ 8 Aux
12 Screens
+ 8 Aux
Max 4K60 mixing layers
(capacity 2)
4 4 8 8 12 up to 8 up to 12
Max DL split layers
(capacity 1)
16 16 32 32 48 up to 32 up to 48
Set Output capacity
In Preconfig > Screens / Aux Screens > Outputs tab, set capacity for each output.
1. Click an output.
2. Set if this output is used as Screen or Aux.
3. Select the output capacity.
Screens
7.3.3.1 Create a Screen
In Preconfig > Screens / Aux Screens > Screens tab, click a Screen to show more options:
Note: An output must be set to Screen mode to be assigned in a Screen.
- Enable/disable the Screen
- Select the Layer mode (Mixing layers or Split layers)
- Use drag and drop to assign Outputs to a Screen.
- Use to unassign an Output.
- In Layers , use the Add layer and buttons to set the Layer quantity.
- Click Apply to save new configuration.
The number of remaining layers is indicated, it depends on layers capacity and the use of Cut & Fill .
Note: For more information about using Cut & Fill, see 14.2.3 Cut & Fill effect page 76 .
Tip : - All pending changes are identified with a * and listed in the Summary. If needed, click to cancel pending changes.
- The Optimized notifier shows when the Optimized mode is enabled.
- It is possible to modify layers capacity after creation without removing all layers.