Web Configuration Interface
37
PTE-300 PosiTrack Ethernet Camera Controller
Change Username and Password
You can enable or disable username and password protection for the interface. If you disable username/
password security, anyone can access the interface at any time. With security enabled, all of the
interface’s setup pages will be protected with a username and password, although you will only need to
enter this information once when you access the interface.
You can change the username and password to control access to the interface. Both the username and
password are case sensitive, and only the username is displayed. The default username and password are:
To change the username or password:
1.
From the
Security
page, select whether Security is Enabled or Disabled.
2.
Enter the
New Username
.
3.
Enter the
New Password
.
4.
Click the
Update Username and Password
button to save your changes.
Remote Access
You can specify up to four TCP ports that needs protection. Ports may be protected so that only
computers with certain IP addresses can have access to the interface. You can set three parameters for
each protected port:
Port Number
- the number of the port you wish to have protected. These port numbers should
correspond to the port numbers in the
Services
web page. For example, the factory default port
of 80 is used for HTTP. Access is only restricted for port numbers which are listed here. If a
port number is not listed, then it has no access restriction.
IP Address
- the complete or partial IP address that will have access to the port.
IP Mask
- a mask value which allows you to specify a range of IP addresses. The mask is
ANDed with the IP address which is accessing the interface and then compared to the IP
Address above.
1.
From the
Security
page, select whether Remote Access is
Enabled
or
Disabled
.
2.
Enter the Authorized Port Number, Authorized IP Address, and IP Mask values for each port to be
enabled for remote access.
3.
Click the
Update Remote Access
button to save your changes.
Default Username
Default password
Admin
1988
If you change and then forget the new username/password, the default username
and password cannot be restored. If this happens, return the PTE-300 to the factory.
Summary of Contents for PTE-300
