AMX PTE-300, Operation/Reference Manual, Page: 15 / 44

Installation
11 PTE-300 PosiTrack Ethernet Camera Controller
Camera/Lens Mounting and Balancing
The camera/lens assembly should be mounted so the tilt axis is capable of going through the optical axis
of the camera, assuming the optical centerline is between 1/2” (12.70 mm) and 5" (127.00 mm) above
the mounting plane of the camera lens. The mounting platform (camera cradle) allows the camera/lens to
be mounted with its center of gravity on the tilt axis. The maximum weight of the camera/lens
assemblies on the PTE-300 is 30 lbs. (13.6 kg). The camera cradle is mounted to the Tilt Hub (FIG. 14).
To mount and balance the camera/lens:
1.
Separate the camera mount and the cradle support bracket by removing the two 1/2” screws on the
underside of the assembly (see FIG. 15) using a 3/32” Allen wrench.
2. Install the camera alignment peg to the mount at the position that best fits the camera/lens.
3.
Secure the camera/lens to the mount (at the camera alignment peg) with the 1/2” screw and
1/10” thick washer supplied (see FIG. 15).
FIG. 14 Tilt Hub dimensions for the PTE-300
0.750"
19.05 mm
0.750"
19.05 mm
0.750"
19.05 mm
0.750"
19.05 mm
0.250"
6.35 mm
0.00"
0.00"
Position
markers
Camera points
in this direction
1.50"
38.1 mm
0.250"
6.35 mm
Do not lift the PTE-300 by the Camera/Lens cradle, as this could damage internal
components.
FIG. 15
Camera bracket assembly
Mounting holes (three sets)
Cradle support bracke
Camera alignment peg
Camera/Lens cradle
assembly (side view)
Camera mount
(underside view)