![background image](http://html.mh-extra.com/html/amx/dxlink/dxlink_instruction-manual_2938738071.webp)
Network Configuration
71
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
4.
Once all actions in Step 3 are completed, the LEDs all turn off, indicating the unit is ready to reboot.
The unit automatically reboots to complete the process.
Tip:
To monitor the ID Pushbutton boot state of a module, see the “ID Pushbutton Boot and NetLinx LED
Behavior” table below.
ID Pushbutton Boot State and LED Behavior
To monitor the ID Pushbutton boot state of a module by its LEDs, check both the Link/Act and Status LED columns.
ID Pushbutton Boot and NetLinx LED Behavior
ID Pushbutton Boot States
Link/Act LED
Status LED
Boot with ID Pushbutton held down
Slow blink (1 Hz)
Slow blink (1 Hz)
ID Pushbutton held down long enough for
reset to default parameters
Fast blink until ID Pushbutton is
released, then OFF
Fast blink until ID Pushbutton is
released, then OFF
ID Pushbutton held down long enough for
reset to default firmware image
Solid ON, transitions to OFF once
the unit completes writing to flash
and is ready to reboot
Solid ON, transitions to OFF once
the unit completes writing to flash
and is ready to reboot
In Auto ID mode
Normal
Blink (2 Hz)
ID Pushbutton held down long enough to
accept new ID
2 blinks, then normal
2 blinks, then normal
After boot: ID Pushbutton held down, but not
long enough for IP mode change
Slow blink (1 Hz)
Slow blink (1 Hz)
After boot: ID Pushbutton held down long
enough for IP mode change
Fast blink, then OFF
Fast blink, then OFF