Product Overview and Specifications
27
Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver
3.
Select the Power Management tab and click “Allow this device to wake the computer.”
4.
Click OK.
5.
Repeat steps for HID mouse (in the Device Manager dialog box, expand “Mice”).
HID Devices
A list is available of HID devices which have been tested and found to be working well with the latest firmware
(see “DXLink - HID supported Devices” on the DXLink Receiver’s product page at http://www.amx.com/
products/AVB-RX-DXLINK-HDMI.asp).
USB LED
The USB LED on the front of a Transmitter or Receiver Module monitors the USB port on the rear of the unit.
The USB LED illuminates (yellow) when a USB device is detected (the port default is “enabled”).
To disable the port on the Transmitter, either disconnect the cable or send the following SEND_COMMAND:
USB_HID_SERVICE-DISABLE
. The enable/disable command persists through power cycling. To enable the
port, send:
USB_HID_SERVICE-ENABLE
. The USB ports support a limited number of SEND_COMMANDs,
see page 94.
HDCP Compliance
If the connected downstream sink is not HDCP compliant, then the HDMI output on the Receiver will not send the
signal. This does not affect additional displays the source may be routed to, i.e., HDCP compliant displays will
still show content from the source device even when the source device is also routed to non-compliant displays.
Non-compliant devices can be easily identified because they display a dark red image or an orange image to
indicate the authentication process failed.
IR Control on HDMI TX, Multi-Format TX, and HDMI RX (Optional)
The following two items are required for IR control. In addition, a compatible remote control unit can be used
with the system. (The two items listed are not included with the modules.)
IR03
– External IR Receiver Module (FG-IR03). The IR03 can be connected to the IR RX port on the
Multi-Format TX or HDMI TX or to the IR RX port on the HDMI RX, allowing IR signals to be received
from a compatible IR remote control. The IR03 allows the Multi-Format TX or HDMI TX to be placed
behind the display device if desired.
CC-NIRC
– NetLinx IR Emitter Cable (FG10-000-11). The CC-NIRC can be connected to the IR TX port on
the Transmitter or to the IR TX port on the HDMI RX. This allows IR signals to be sent to the source device
from the Multi-Format TX or HDMI TX or to the display device from the Receiver.
Select this option
USB LED info
