Appendix B – Telnet (Terminal) Commands
108
Instruction Manual – DXLink Fiber Transmitters and Receivers
Telnet Commands (continued)
CLEAR USB STATS
Note:
This command applies only to the Transmitter.
Clears the USB statistics.
DATE
Displays the current date.
DEVICE STATUS
Displays device status of a specified device, port, system (<D:P:S>).
Note:
Devices other than the DXLink Fiber device itself will be ignored.
Example:
>device status 32002:1:0
Device Status
-------------
Device 32002 AMX LLC, DXF-TX-xxD, v1.2.6 contains 8 Ports
Port 1 - Channels:255 Levels:8
MaxStringLen=64 Types=8 bit MaxCommandLen=64 Types=8 bit
The following input channels are on:None
The following output channels are on:None
Level 1=0 Supported data types=UByte,UInt
Level 2=0 Supported data types=UByte,UInt
Level 3=0 Supported data types=UByte,UInt
Level 4=0 Supported data types=UByte,UInt
Level 5=0 Supported data types=UByte,UInt
Level 6=0 Supported data types=UByte,UInt
Level 7=0 Supported data types=UByte,UInt
Level 8=0 Supported data types=UByte,UInt
DIPSWITCH
Displays the current value for each of the DIP switch’s four toggles.
Example:
>dipswitch
Board Switch Settings:
DIP# Setting Description
1 ON: Enable ICS LAN
2 OFF: Manual DXLink mode
3 ON: Enable Network
4 OFF: Force unidirectional mode
DNS LIST
Displays list of DNS settings.
Example:
>dns list
DNS List
-------------
Domain suffix: amx.internal
The following DNS IPs are configured
Entry 1: 192.168.40.7
Entry 2: 192.168.40.8
ECHO
Note:
This command applies only to the Transmitter.
Toggles echo of local characters on and off. Enter “echo on” or “echo off” or simply re-enter
“echo” to toggle between on and off.
ENCODER
Note:
This command applies only to the Receiver.
Shows video encoder status.
Example:
>encoder
--------------------------------
Video Encoder (ADV7511)
TMDS On
Mute Unmuted
HDCP Screen No
EXIT
Closes the current Telnet session.
FACTORY APP
Note:
This command only applied to the Transmitter.
Resets the application to the factory image.
Note:
This command does not reset the factory parameters.
