VClink Codec Master Control System
Operational Quick Guide
67
3.
Using the numeric keypad in the Manual Dial Section, enter your number. If
you make an error use the Delete button to delete the last digit.
4.
Press the Send button to place the call.
Hanging up a call
From any control screen touch the Hang Up button, located in the Line Section, to
disconnect your call.
Receiving a call
The system allows for automatic and manual answering of incoming calls. The
following section provides information on both of these scenarios.
If the local system is in Auto Answer mode
If the Auto Answer function is enabled, any incoming call will be automatically
connected. The Auto Answer button is available in the Line Section from the
CONF, DIAL, CALL STATUS, and ECHO CANCEL control screens. A green high-
light indicates that the button is depressed.
Figure 53
Manual Dial Control page
Summary of Contents for Codec Master Control System
