AMX Codec Master Control System, Instruction Manual

Page: 27 / 90

VClink Codec Master Control System Setup and Configuration 19
Setup & Configuration
Overview
This section explains how to set-up and configure the codec using VClink soft-
ware.
Powering the System
To apply power to the system:
1.
Turn on the power switch to the codec.
2. Connect the supplied 6 foot AC U.S. power cord on the PS4.2 to a 110V AC
50/60 Hz power supply.
3. The AXlink and TX/RX LEDs on the AXB-EM232 blink, the Touch Panel
beeps, and the codec goes through a self-test
4. The AXlink LED blinks once per second, indicating that power is active and
AXlink communications is functioning.
The first page that displays on the touch panel is the AMX title page (Figure
18).
Figure 18
Title page