1-59
S-4001 ISBH+I SM 30°
Released: 09/2017
E-mail: [email protected]; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
F - INDEXER - ANGLE 30°
5. THE INDEXER CLAMPING FEED PRESSURE ADJUSTMENT
1. First place the material under the left clamping feed.
2. Press the button
on display. Pull the clamped material and check if the material is held well.
3. Do the same with the right clamping feed.
4. If the pressure is not the same on both clamping feed, follow the below mentioned steps:
The left clamping feed holds the material more than the right one
a) Press the left clamping feed
1
by hand down to the clamp mat.
b) Move the right clamping feed
2
closer to the clamp mat by loosing the screw
3
on the right clamping feed.
c) Tighten the screw
3
and release the left clamping feed by hand
1
.
The left clamp foot holds the material less than the right one
a) Press the left clamping feed by hand down to the clamp mat.
b) Move the right clamping feed back from the clamp mat by loosing the screw on the right clamping feed.
c) Tighten the screw and release the left clamping feed by hand.
Check the correction of the adjustment according to the points 1-4.
NOTE:
Since the clamp cylinder is closer to the right clamping feed, it is necessary to set the stronger pressure on
the left clamping feed.