AMF REECE S-311, Parts And Service Manual, Page: 72 / 142

S-311
1-60
Released:01/2014
E-mail: service@amfreece.cz; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
E - STANDARD MACHINE ADJUSTMENT
17. MECHANISMUS ADJUSTING FOR CT GIMP
Gimp auxiliary stretcher adjusting:
Adjusting performed as follows: the stretcher slightly holds the gimp and when turning the race in the end of buttonhole
where the gimp does not run from the coil but the thread end is shorter after the throat plate trimming
Over tension in stretcher might cause the buttonhole deformation in eye.
The gimp guide adjustment in base:
Thanks to adjusting gimp guide in base we can extend or reduce the gimp length after the trim in throat plate.
By moving the guide in direction to the machine operator, the gimp length is reduced after the trim and moving the
guide in opposite direction from the machine operator the length is extended.
The correct gimp length after the trim is 4mm (in basic machine position).
Security
screw
loosing
tightening
Factory setting