S-311+I
1-15 I
Released: 01/2014
E-mail: [email protected]; webside: amfreece.com
Phone: +420 582 309 146; Fax: +420 582 360 606
D - MACHINE CONTROLS
1. SEWING A BUTTONHOLE
1.1. Set the machine into the home position as in section
C1
of this chapter. Before starting sewing, let the machine
warm up in this condition for about 3 minutes.
1.2. Check, if threads are correctly threaded as indicated
in section
C3
, and place the work piece under the
machine clamps. Correct placement of the buttonhole on
the work piece will facilitate front stopper
1
and side
stopper
2
that have adjustable lenghts.
1.3. Pressing slightly the foot pedal into the first position
will activate clamping and the work piece will be clamped.
(Releasing the foot pedal will lift the clamps up again).
1.4. Pressing the foot pedal down (into the second position) will start sewing the buttonhole, which has been selected
in the program. Once the buttonhole is sewn, fabric cut and upper thread trimmed, the clamps go up and the machine
comes back into the home position.
1.5. Once the clamps are lifted up, it is possible to move the work piece in order to sew another buttonhole. If the
Indexer device is activated, the fabric is moved automatically.
1.6. The machine can be stopped by the button STOP
3
which is located on the machine arm, at any phase of the
cycle.
Releasing this button will stop the machine (Error E01, see section Troubleshooting).
1.7. Once sewing finished, switch the machine off. We also recommend unplugging the power cable from the socket
and shutting the air supply off.