Ametek TM2000 Pro, User Manual, Page: 102 / 148

5-30 | TM2000 Oxygen Analyzer
Set Cal timers
Set Cal timers Function/Option
Set Auto Timers Set cycle times for auto calibration/verification
Set Time and Date Set current time and date
Auto Cal On/Off Enable or disable auto calibration cycle
Cal Gas Duration
Define how long cal gases should flow through the sen -
sor during automatic calibration or verification
Recovery Duration
Define a recovery duration during which time the sen -
sor switches from measuring calibration gas readings to
measuring process readings without affecting the analog
output or triggering alarms
Set auto timers
Set the frequencies for automatic calibrations or verifications
, including the
time when the first calibration or verification starts. Set the cycle in either hours
or days.
Auto calibration cycle must be enabled to perform an automatic
calibration or verify ( Auto Cal On/Off ).
If you schedule a verification and calibration at the same time, the
verification will be performed first, then the calibration.
If using a digital input to start an auto calibration or auto verify, you
must select Calibrate or Verify from the Remote Switch Configu -
ration option from the Setup Key menu.
1. From the Set Cal Timers menu, select Set Auto Timers .
2. Select Auto Cal Cycle to define an automatic calibration cycle. Select Auto
Verify Cycle to define an automatic verification cycle.
3. Select Set Cycle in DAYS or Set Cycle in HOURS to set the frequency of
calibrations or verifications in days or hours.
If you are setting the auto timers for the first time, Series 2000 software will au -
tomatically prompt you to enter the current time and date after timers are set up.
Enter the frequency for the calibration or verification cycle (either in days or
NOTE

NOTE

NOTE
