4-16
Operator's Manual
•
Although it appears to have three Patterns available to program, you
can only program the Auto Pan feature for Pattern 1.
•
Any extraneous movements made during the Auto Pan programming
will be ignored when the programming is complete. Once the end
point of the Auto Pan is set, the result will be a smooth pan between
the start point and the end point of the Auto Pan.
•
Do not attempt to create an Auto Pan that is greater than one
revolution (360º) of the SpeedDome LT. The dome will accept this
pattern during programming; however, it will not work when you
attempt to run the pattern. The starting point and the ending point
must be less than one revolution of the SpeedDome for the Auto Pan
to work properly.
•
If you attempt to program Pattern 2 or 3 as different Auto Pans for
the dome, the system will take you through the motions of the
programming. However, the new Auto Pan will not be saved. Do not
attempt to program more than one Auto Pan per SpeedDome LT.
•
If you need to re-program the Auto Pan for the dome, you must
select the Pattern 1. Selecting another available Pattern number will
not change the previously programmed Auto Pan.
To program the Auto Pan for SpeedDome LT, do the following:
Tip: You must use the Main T
OUCH
T
RACKER
to define the Auto Pan for
SpeedDome LT.
1.
Using the number buttons, enter the number of the SpeedDome LT for
which you are defining the Auto Pan (for example, camera 3). Then
press the
Camera
button.
2.
Pan and tilt the camera to the starting point of the Pattern, and then zoom
and focus the camera accordingly.
