3-12
Operator's Manual
output off). The List of Inputs and Outputs provides the on and off states
for each output.
Depending on whether you turned the output on or off in the previous
step, the LCD displays one of the following messages:
Cam 13
Output On
Cam 13
Output Off
-or-
If you entered an invalid output number (any number greater than 4 or an
output that does not exist) the T
OUCH
T
RACKER
beeps.
Clearing System Alarms
Tip: Alarms can be cleared from the Main T
OUCH
T
RACKER
only.
Your system can be configured to handle up to 64 different alarms. When an
alarm is triggered, it takes precedence over whatever you are doing on the
Main monitor and Main T
OUCH
T
RACKER
at the time. For example, if you
are in the programming mode when an alarm comes in, the alarm information
replaces the programming information on the LCD. If you are running the
Sequence when an alarm comes in, the alarm information will replace the
Sequence information on the LCD. In addition, the video information for the
alarm will replace the video information from the Sequence on the Main
monitor.
The Call monitor and Call T
OUCH
T
RACKER
remain unaffected by incoming
alarms.
Each alarm can be configured to automatically call up video and initiate an
output. For example, when an alarm is triggered, it can automatically run a
specific Pattern and set off an audible alarm. In addition, whenever an alarm
is triggered, the T
OUCH
T
RACKER
will beep, signaling an active alarm. The
T
OUCH
T
RACKER
will continue to beep intermittently until the alarm is
cleared.
