Amcrest General 1080P(V2) Mini 1U Series, User Manual, Page: 47 / 188

38
Item Note
The larger the number, the strong the color is. This value has
no effect on the general brightness of the whole video. The
video color may become too strong if the value is too high. For
the grey part of the video, the distortion may occur if the white
balance is not accurate. Please note the video may not be
attractive if the value is too low. The recommended value
ranges from 40 to 60.
Gain The gain adjust is to set the gain value. The default value may
vary due to different device models. The smaller the value, the
lower the noise, but the brightness is also too low in the dark
environments. It can enhance the video brightness if the value
is high. But the video noise may become too much.
Color mode It includes several modes such as standard, color, bright, and
gentle. Select a color mode, the sharpness, brightness,
contrast, etc and it will automatically switch to the
corresponding setup.
4.4.4 Search
Please refer to chapter 4.8.1 for detailed information.
4.4.5 Manual Record
Please refer to chapter 4.10.5.3.1 for detailed information.
4.5 Navigation Bar
You need to go to the Main menu->Setting->System->General to enable navigation bar function;
otherwise you can not see the following interface.
The navigation bar is shown as below. See Figure 4-15.
Figure 4-15
4.5.1 Main Menu
Click button to go to the main menu interface.
4.5.2 Output Screen
Select corresponding window-split mode and output channels.
4.5.3 Favorites
Click button and the system displays the favorites drop down menu. Once the desired layout of
cameras is achieved,
click this button and select “Add to Favorites”. A window will appear for you to
name the favorite. To remove a favorite, select “Trim Collection”.
4.5.4 Color
Click button and the system goes to the color interface. Please refer to chapter 4.4.3.
4.5.5 Search
Click button and the system goes to the search interface. Please refer to chapter 4.8.1