83
detection zones will not go into effect. Clicking the escape button to leave the motion detection
zone and will not save the zone setup.
•
Record Channel:
This checkbox allows the user to enable the system to record video for that channel when a
motion detection alarm is triggered. Delay is also associated with this tab, it is the This field specifies in
seconds how long the delay between alarm activation and recording should be.
•
PTZ Activation:
Allows the user to active PTZ functionality to applicable PTZ devices.
•
Tour:
Allows the user to enable the camera to activate a PTZ tour when a motion detection alarm is
triggered.
•
Snapshot: A
llows the user to enable the camera to take a snapshot when a motion detection alarm is
triggered.
•
Video Matrix:
Allows the user to customize the display of their current video outputs.
•
Voice Prompts (N/A):
Allows the user to customize voice prompts for motion detected events.
•
Show Message:
This checkbox allows the user to enable the system to show an on-screen message when a
motion detection alarm is triggered.
•
Send Email:
This checkbox allows the user to enable the system to send an email when a motion detection
alarm is triggered.
•
Buzzer:
Allows the user to trigger a buzzer once a motion event is detected.
•
Log:
Allows the user to log all motion detected events that are triggered in the device.
•
Alarm Upload:
This checkbox allows the user to enable the system to upload alarm information when a
motion detection alarm is triggered.
To revert to default settings, click the Default button near the bottom left hand corner. To copy settings to
another channel, click Copy near the bottom left hand corner. To test a channel’s motion detection, click Test
near the bottom left hand corner. To confirm settings, click the OK button near the bottom right hand corner. To
cancel any modifications, click the Cancel button near the bottom right hand corner. To apply the settings, click
the Apply button near the bottom right hand corner.
4.10.3.3 Video Loss
The video loss settings screen is where the DVR can be setup to notify the user any time there is video loss on any
of the channels. Below is a screenshot of the video loss settings screen:
