Version 1.1.1 dated February 25th, 2013
Page 24
Original operating instructions
MT50
GB
Fig. 3-3: Drawing of the anchoring
3.5
First commissioning
ATTENTION!
Before commissioning the machine check all screws, fixtures resp. safety devices
and tighten up the screws if necessary!
WARNING!
Risk by using improper tool holders or operating them at inadmissible speeds.
Only use the tool holders (e.g. arbor) which were delivered with the machine or which
are offered as optional equipment by OPTIMUM.
Only use tool holders in the intended admissible speed range.
It is only allowed to modify tool ho
lding fixtures in compliance with the
recommendations of
OPTIMUM or the manufacturer of the clamping device.
WARNING!
When first commissioning the milling machine by inexperienced staff you endanger
people and the machine.
We do not take any liability for damages caused by incorrectly performed
commissioning.
3.5.1 Cleaning and lubricating
Remove the anti-corrosive agents on the milling machine which had been applied for
transportation and storage. Therefore, we recommend you to use paraffin.
Do not use any solvents, cellulose thinner or any other cleaning agents which might
affect the coating of the milling machine when cleaning the machine. Observe the
indications and notes of the manufacturer for cleaning agents.
Oil all blank machine parts using an acid-free lubricating oil.
3.5.2 Assembly of the chip tray
If it is not yet pre-assembled, assemble the chip tray using the fixing materials included
in the scope of delivery.
3.5.3 Electrical connection
Connect the electrical supply cable.
Vibration and
noise insulating material
Threaded rod as anchor rod, optionally
Shear connector cartridge M12