Version 1.1.1 dated February 25th, 2013
Page 14
Original operating instructions
MT50
GB
1.9
Safety check
Check the milling machine at least once per shift. Immediately inform the person responsible
of any damage, defect or change in operating function.
Check all safety devices
at the beginning of each shift (at continuous operation),
once a week (with the machine in operation),
after every maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the milling machine
are legible (clean them, if necessary),
are complete.
INFORMATION
Use the following table for organizing the checks.
1.10 Personnel protective equipment
For some works you need personnel protective equipment as protective equipment.
Protect your face and eyes: wear a safety helmet with facial protection when performing
works where your face and eyes are exposed to hazards.
Use protective gloves when handling pieces with sharp edges.
Use safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the prescribed personnel protective equipment is
available at the working place.
General check
K
O
k
c
e
h
C
t
n
e
m
p
i
u
q
E
Protective covers
Mounted, firmly bolted and not damaged
Signs,
Markings
Installed and legible
Date:
Checked by (signature):
Functional test
K
O
k
c
e
h
C
t
n
e
m
p
i
u
q
E
EMERGENCY-STOP
switch
When the EMERGENCY STOP push button is activated, the milling
machine must switch off. Make sure that it is only possible to restart the
machine if the EMERGENCY STOP push button is unlocked.
Date:
Checked by (signature):