Amazone ZA-V, Operating Manual, Page: 132 / 136

Cleaning, maintenance and repairs
132 ZA-V BAG0087.11 01.20
12.9.4 Installation and removal of hydraulic hose lines
When installing and removing hydraulic hose lines, always observe
the following information:
•
Only use original AMAZONE hydraulic hose lines.
• Ensure cleanliness.
• Always install the hydraulic hose lines to ensure the following in
all operational positions
ο
There is no tension, apart from the hose's own weight.
ο There is no possibility of jolting on short lengths.
ο Outer mechanical influences on the hydraulic hose lines
are avoided.
Use appropriate arrangements and fixings to prevent abra-
sion of the hydraulic hose lines by components or from
rubbing against one another. If necessary, secure hydraulic
hose lines using protective covers. Cover sharp-edged
components.
ο The approved bending radii may not be exceeded.
• When connecting a hydraulic hose line to moving parts, the hose
length must be appropriate so that the smallest approved bend-
ing radius is not undershot over the whole area of movement
and/or the hydraulic hose line is not overtensioned.
•
Fix the hydraulic hose lines at the specified fixing points. There,
avoid hose clips, which impair the natural movement and length
changes of the hose.
•
The coating of hydraulic hose lines is not permitted.
12.9.5 Checking the hydraulic fluid filter
Hydraulic fluid filter (Fig. 71/1) with contamina-
tion indicator (Fig. 71/2):
•
Green Filter fully functional
• Red Replace filter
To remove the filter, twist off the filter cover and
remove the filter.
Fig. 79
WARNING
Beforehand, depressurise the hy-
draulic system.
After replacing the filter, press the contamination
indicator back into place.
→
Green ring again visible.