Coupling and uncoupling the machine
WARNING
Risk of crushing, being caught or pulled in, or impact when the
machine is unexpectedly released from the tractor.
•
Use the intended equipment to connect the tractor and the ma-
chine in the proper way.
•
When coupling the machine to the tractor's three-point hydraulic
system, ensure that the attachment categories of the tractor and
the machine are the same.
Be absolutely certain to upgrade the machine's category II lower
link pin to category III using reducing sleeves if your tractor has
a category III three-point linkage.
•
Only use the upper and lower link pins provided to couple up the
machine (original pins).
•
Check the upper and lower link pins for visible defects whenever
the machine is coupled. Replace the upper and lower link pins in
the event of clearly visible wear.
•
Secure the upper link pin and lower link pin in the attachment
points of the three-point attachment frame against unintentional
detachment using a linchpin.
•
Perform a visual inspection to ensure that the upper and lower
link hooks are correctly locked before reversing the tractor.
WARNING
Risk of energy supply failure between the tractor and the ma-
chine due to damaged power supply lines.
During coupling, check the course of the power supply lines. The
power supply lines
•
must give slightly to all movement of the connected machine
without tensioning, kinking or rubbing.
•
must not chafe against other parts.
1. Direct people away from the danger area between the tractor
and machine before you approach the machine with the tractor.
2. Couple the supply lines first before coupling the machine with
the tractor.
2.1 Drive the tractor up to the machine, leaving a clearance of
approximately 25 cm between tractor and machine.
2.2 Secure the tractor against unintentional starting and unin-
tentional rolling.
2.3 Check whether the universal joint shaft of the tractor is
switched off.
2.4 Couple the PTO shaft and supply lines with the tractor.
2.5 Hydraulic brake: fasten the parking brake pulling cable to
the tractor.
3. Now reverse the tractor towards the machine so that the con-
nection fitting can be coupled.
4. Couple the connection fitting.
5. Lift the stand into transport position.
6. Remove wheel chocks, release parking brake.
150
UX Super
BAG0054.10 11.16