Adjustments
Citan BAG0014.4 09.14
79
8.2
Setting the seed level sensor
The level for the filling level sensor can only be
adjusted when the seed hopper is empty:
1. Stop tractor engine, apply parking brake
and remove ignition key.
2. Use the stair steps (Fig. 60) to climb into the
seed hopper.
Fig. 60
3. Slacken thumb nut (Fig. 61/2).
4. Adjust the level of the filling level sensor
(Fig. 61/1) according to the desired residual
amount of seed.
5. Tighten thumb nut.
Fig. 61
Important!
The filling level sensor should not
rest on the hopper!
Hint!
Increase the residual amount of
seed which triggers the alarm
•
the coarser the seed
•
the bigger the sowing rage
•
the larger the working width.
8.3
Adjusting the output volume on the gearbox
The desired seed rate is set by the gearbox set-
ting lever (Fig. 62/1).
By the gearbox setting lever (Fig. 62/2) the
speed of the metering shaft and thus the seed
rate can infinitely variably be set. The higher the
figure on the scale (Fig. 62/4) has been chosen
by the pointer (Fig. 62/3), the higher the seed
rate will get.
Fig. 62
Hint!
If your machine is equipped with the
seed rate remote control, set the
desired gearbox position according
to
AMATRON 3
!