38
PIX-25
PIX-25 View Description
Internal View
The 4 function buttons are used to navigate through the Setup Mode to
change the clock’s settings.
The
PROGRAM
button is used to enter/exit the Program Mode and exit any
sub-program menu.
The
ENTER
button is used to accept the information shown on the display
and save it in memory.
The
CHANGE
button is used to select/advance through information shown
on the display.
The
+1 HOUR
button is used to advance 1 hour per press on the display
while not in the programming mode.
The
+1 MINUTE
button is used to advance 1 minute per press on the
display while not in the programming mode.
The
RESET
button on the bottom rear of the clock will restart the clock
with no change to user settings, time, and ink capacity.
Need Ribbons, Keys and Accessories?
Visit
The Atomic Time Synchronization Indicator in the
LCD Display indicates the status of the signal. When
you first receive the clock, it may be necessary to adjust
the hour and minute.
This Atomic Time
Synchronization feature is not available in Hawaii
and Alaska.
Whenever the time is changed on the clock by the user the “Signal Found”
Atomic Time Synchronization Indicator will be turned off and just the
“Searching for Signal” indicator will be displayed. The clock will automatically
resynchronize the time (minutes and seconds) by searching for the Atomic
Time signal.
Note
– The atomic clock feature must be enabled for this time
synchronization process. Amano recommends facing the front of
the clock (display side) either in the South or North direction to
increase potential atomic time signal reception.
: 866-487-4751
VISIT: WWW.TIMECLOCKEXPERTS.COM
: 866-487-4751
WWW.TIMECLOCKEXPERTS.COM
