24
PIX-25
5.
Press the
ENTER
button once and the clock will display
00
with the first
digit flashing.
6.
Keep pressing the
CHANGE
button until the display shows the desired
first digit such as
3
.
7.
Press the
ENTER
button once to advance to the 2
nd
digit. Keep pressing the
CHANGE
button until the
display shows the desired 2
nd
digit such as
2
.
8.
Press the
ENTER
button so both digits flash.
9.
Press the
ENTER
button to perform the clear function and exit ALL
programming. By entering code 32, the clock resets all user settings
(except the total print number and date time) to the factory defaults
settings. The clock displays the message “
WAIT
” and “
RESET
” on the LCD
screen and restarts. Note: If an invalid two digit password is entered the
display will flash “
error
”.
Enter
03
to disable the atomic clock.
Enter
04
to enable the atomic clock.
Enter
11
to turn on display atomic sync.
Enter
12
to turn off display atomic sync.
Enter
13
to reset 6 digit count.
Enter
32
to clear memory.
Enter
98
to clear all parameters plus the total print number.
Note FAQ
– If the Atomic Clock feature has been turned off,
pressing the “Reset” button or changing the time will not turn the
feature back on. The feature must be Enabled by following the
above steps.
Warning Message (
d
5
)
Use this diagnostic to check the PIX-25 LCD for any warning messages.
1.
With the cover removed, press and hold the
PROGRAM
button until
P1
TIME
appears to begin the programming mode.
2.
Keep pressing the
CHANGE
button to change the current programming
mode until the display shows
P7 DIAGNOSE
.
3.
Press the
ENTER
button once and the clock will display the sub menu
d1
SOFT REV
.
4.
Keep pressing the
CHANGE
button until the display shows
d5
WARNING
.
5.
Press the
ENTER
button once and the clock will display
the most recent warning message. If there are no
warning messages, the clock will display the text
NONE
.
: 866-487-4751
VISIT: WWW.TIMECLOCKEXPERTS.COM
