Amada ML-2550A, Operation Manual

Page: 79 / 229

1. Setting Welding Schedules
79
ML-2550A/2551A
Chapter 2 V
arious Settings
Introduction Part
Inst
allat
ion and Preparation Part
Operating Part
Maintenance Part
Appendixes
<Note>
The settable maximum peak value of laser output differs depending on the model.
ML-2550A: 8.0 kW / ML-2551A: 5.0 kW
(5) Press the laser output time "TIME [ms]" and laser output value "POWER [%]"
setting buttons of "FLASH1" to "FLASH3."
Enter each value.
⇒ The laser output time is set in the range of 0.0 to 99.9 ms. Regarding the laser
output value, the ratio (%) based on the case where the set laser output peak
value is 100% is set.
<Note>
Set the laser output time so as to result in the following value.
0.25 ms ≤ FLASH3 ≤ 100.0 ms
(6) To insert non-laser output time between "FLASH1" and "FLASH2", press the
COOL button to set the output stop time (ms) in "COOL1."
(7) To insert non-laser output time between "FLASH2" and "FLASH3", press the
COOL button to set the output stop time (ms) in "COOL2."
(8) Press the "

SLOPE" setting button.
Enter the time "TIME [ms]" required for laser light to up-slope (get gradually
stronger) in FLASH1.
<Note>
The output time of FLASH1 includes the time of "

SLOPE."
Set "

SLOPE" so as to result in the following value.

SLOPE ≤ FLASH1
(9) Press the "

SLOPE" setting button.
Enter the time "TIME [ms]" required for laser light to down-slope (get gradually
weaker) in the last FLASH.
<Note>
The output time of the last FLASH includes the time of "

SLOPE."
Set "

SLOPE" so as to result in the following value.

SLOPE ≤ FLASH1, FLASH2, FLASH3
(10) To output laser light several times for one second, press the "REPEAT" setting
button and then set the laser light output count for one second in the range of
000 to 500 pps (pulse per second).
⇒ When 0 is set, a single output is performed.
(11) To output laser light repeatedly, press the "SHOT" setting button and set the laser
light output count in the range of 0000 to 9999.
⇒
When "REPEAT" is not 0 and "SHOT" is set to 0, laser light is continuously output
until a laser stop signal is input.