
32
ML-2550A/2551A
2. Name and Function of Each Section on the Top Side
2. Name and Function of Each Section on the Top Side
Top Cover Section
This section explains each section of the top cover of the main unit.
Function of Each Section on the Top Cover
(1)
Optical Fiber
Inlets
Make the required number (number of deliveries) of holes in the rubber cap.
Pass the optical fibers through these holes and connect them to the
laser beam input units. These inlets are on the top and rear side.
The output units connected to the optical fiber input ports are numbered
as 1, 2, 3, and 4, from the left.
(2)
Lamp-Replacing
Cover
This is a cover of the flashlamp portion. Before replacing the flashlamp,
open this cover.
(3)
Head Cover A, B
This is a cover for the laser oscillator section.
(4)
Laser Controller
This controller sets welding conditions and operates the laser welder.
The setting items and set values are displayed on the liquid crystal display.
(5) EMERGENCY
STOP Button
This is an emergency stop button. With this button pressed, the laser
welder operation is stopped and the same state as that provided by
turning OFF the CONTROL keyswitch is provided. The same state as
that provided by turning OFF the MAIN SWITCH switch is provided in
the case of CE. However, the power supply circuit is alive. When the
pressed button is turned in the direction of RESET (clockwise), the
button is reset to the initial state.
(6)
CONTROL
Keyswitch
When the CONTROL keyswitch is turned ON with the MAIN SWITCH
switch ON, this keyswitch is operable. When the laser is not used, turn
OFF the CONTROL keyswitch and then pull out the key. The laser
safety supervisor should take charge of the keyswitch.
MAIN SHUTTER
READY
POWER
4
3
1
2
ON
OFF
SHUTTER
CONTROL
HIGH VOLTAGE
1 2 3 4
(1)
(3)
(2)
(11)
(7)
(8)
(9)
(10)
(6)
(5)
(4)
Summary of Contents for ML-2550A
