6.6.7 Adjusting the section end position
The end position of the sections is pre-set so that the
implement sections are horizontal during operation.
This setting can be adapted to the operating
conditions.
1.
Raise the implement.
2.
To engage the transport lock,
fold the implement sections.
3.
Loosen the lock nut
3
.
4.
Move the setting screw
1
to the desired
position.
5.
Unfold the implement sections.
The setting screws must touch the contact
surface
2
simultaneously.
6.
Tighten the lock nuts.
7.
Make the same setting for the opposite side of the
implement.
1
250 Nm
3
2
CMS-I-00006836
6.6.8 Adjusting the scraper to the roller
The scrapers on the roller are set at the factory. The
scrapers can be adapted to the working conditions.
1.
Loosen the bolt
1
under the scraper.
2.
Move the scraper
2
in the elongated slot.
Roller
Distance between roller
element and scraper
Wedge ring roller KW /
KWM
10 mm to 15 mm
Tooth packer roller PW
0,5 mm to 4 mm
Trapeze ring roller TRW
0,5 mm to 4 mm
3.
To check the distance,
rotate the roller
2
.
4.
Tighten the bolt.
5.
Make the same setting for all scrapers.
1
2
CMS-I-00000933
CMS-T-00010033-A.1
CMS-T-00001534-C.1
6 | Preparing the machine
Preparing the implement for operation
MG7512-EN-GB | C.1 | 29.09.2022 | © AMAZONE
55
