6.6.3 Adjusting the working depth of the side guide plates
The side guide plate ensures that the tilled soil is
not thrown to the side. The working depth can be
adjusted. The soil guiding angle bracket additionally
prevents free-flowing soil from escaping.
1.
Loosen the bolts
1
.
Work application
Working depth
After the plough
-
The side guide plates glide
through the soil at a depth of 1
to 2 cm
For mulch seeding
with coarse organic
residues
+
Install the side guide
plates slightly higher at the
front to allow crop residues to
pass underneath.
NOTE
The adjustment of the working depth must be
adapted to the respective operating conditions.
The optimum adjustment can only be determined
during field operation.
2.
To release the side guide plate from the grid,
push the side guide plate towards the front.
3.
Move the side guide plate to the desired position.
4.
Push the side guide plate into the grid.
5.
Tighten the bolts.
6.
Make the same setting for the opposite side of the
implement.
7.
To check the setting,
seed for approx. 30 m at working speed and then
check the work pattern.
The soil guiding angle brackets may not work too
deep. The soil guiding angle brackets may only level
the soil ridge between the side guide plate and the
trailing roller.
8.
Loosen the bolts.
9.
Move the soil guiding angle bracket
2
to the
desired position.
10. Tighten the bolts.
1
2
3
+
-
CMS-I-00003448
CMS-T-00010046-A.1
6 | Preparing the machine
Preparing the implement for operation
MG7512-EN-GB | C.1 | 29.09.2022 | © AMAZONE
51
