CPCI-QIPC REFERENCE MANUAL
ALPHI TECHNOLOGY CORP.
Page 21
Ver 1.1
Part Number :
739-11-000-4000
Copyright ALPHI Technology Corporation ,1998
6.8 FACTORY USE (P16)
This connector is used at the factory for programming the FPGA.
7. STANDALONE OPERATION
When the board is operated without a CPCI HOST, two signals must be driven in order to
assure correct operation. These signals are provided by placing the correct jumpers on the
board when in stand alone operation. If the board is returned to a PCI hosted environment,
these jumpers must be removed, or they will interfere with the correct operation of the PCI
host.
When the board is operated in stand alone mode, the board can by operated under an
emulator and by downloading and executing programs via the serial port under control of
the bootloader.
7.1 CPCI RESET
This signal must be pulled high by inserting a jumper in location W16 for stand alone
operation. In a hosted environment, it must be removed.
7.2 CPCI BUS CLOCK
The AMCC requires that a CPCI BUS clock be present for its internal operation. This signal
must be driven by the internal clock oscillator when operated in stand alone operation. This
is accomplished by inserting a jumper in location W15 for stand alone operation. In a
hosted environment, it must be removed.
