H - Master
metrology
28
ES
DE
IT
EN
PL
RU
ATTRIBUTE
COMMAND
DESCRIPTION
1
RES3
Sets the resolution to 0.01 mm or 0.0005 in
RST
Resets the device (restarts the device) (it is managed like the “ERR” command)
UNI?
Prints the current measure unit
1
UNI1
Enables the inch <-> milimeter conversion
1
UNI0
Disables the inch <-> milimeter conversion
VER?
Prints all the firmware versions of the instrument with a label for each
VER1?
Prints the firmware version of the module without label
VER2?
Prints the firmware version of the mainboard without label
VER3?
Prints the firmware version of the sensor without label
PCAL?
Prints the last calibration date
NCAL?
Prints the next calibration date
LCK+ (seq)
Locks specific keys. (‘seq’ = ‘0123456789.E’ and ‘+’ or ‘-’)
ULK+ (seq)
Unlocks specific keys. (‘seq’ = ‘0123456789.E’ and ‘+’ or ‘-’)
LN20
Disables the second line of the display
LN21
Enables the second line of the display
PONCE (1/0)
Enables/Disables “Print once” for the probed values
PONCE?
Prints the “Print once” state
1, 2
CHHOLD
Selects the probe holder change mode
1
CONST
Selects the “constant” function
CONST?
Prints the “constant” value
ERR?
Prints information on the last error
!ERR
Reset the error state. Used in place of a parse error, or to replace an executed
command that produced an error
UERRE
Unknown error enable
8.2 LIST OF COMMANDS
