Allmand Maxi-Power MP65 T4F, Operator'S Manual

Page: 73 / 76

Not for
Reproduction
73
Addendum A -
Cam Locks / Arctic Kit
NOTE: Location and configuration of kit components
may differ according to model.
Cam Lock Receptacles
The cam lock receptacles allow for quick connection
and disconnection of loads.
1. Connect the cam lock connectors from the load to
the cam lock receptacles on the lower portion of
the outlet panel on the unit. See Figure A1. Be sure
to connect the load correctly. See Connecting
Loads .
WARNING
Electrocution Hazard. Do not connect or disconnect
loads to the cam lock receptacles while the unit is in
operation.
NOTICE: Do not operate the voltage selector switch
while the unit is in operation. Unit damage may result.
Arctic Kit
Block Heater / Battery Heater
The block heater / battery heater keeps the engine
block and battery heated while the unit is not in use.
The block heater / battery heater should be used
whenever the unit is not in use in temperatures below
32° F (0° C).
1. Plug the female end of a heavy-duty power cord
(not supplied) into the Block Heater / Battery Heater
recessed receptacle (A, Figure A2).
2. Plug the male end of the power cord into a standard
120V outlet.
3. Unplug the block heater / battery heater before
putting the unit into operation.
Battery Charger
The battery charger keeps the battery charged while
the unit is not in use.
1. Plug the female end of a heavy-duty power cord
(not supplied) into the Battery Charger recessed
receptacle (B, Figure A2).
2. Plug the male end of the power cord into a standard
120V outlet.
3. The red light (A, Figure A3) on the battery charger
module, located in the left front section of the
engine compartment (see Figure A3) indicates the
battery is charging. The green light (B) indicates
full charge. (The battery charger can stay plugged
in after the battery reaches full charge without
damaging the battery.)
4. Unplug the battery charger before putting the unit
into operation.
Figure A1
Figure A2
Figure A3