Not for
Reproduction
36 ALLMAND.COM
Operation
44
Fuel line air bleeding device
If the machine runs out of fuel, bleed the air, according to the following procedures.
A180562
<Procedure>
1. Refill the fuel.
2. Set the control power switch [A] to [ON] position.
3. Press the manual mode button [B] to activate the electromagnetic
pump.
4. Loosen the air removal plug [D] of the fuel filter element [C] and
loosen the priming pump [E], push the priming pump [E] back and
forth until fuel comes out (more than 20 times).
5. After air removal is completed, tighten the air release plug [D] and
push the priming pump [E] back and forth until the fuel filter
element [C] is filled with fuel (more than10 times).
6. Wait about 1 minute, and then loosen the air vent plug [D] to
bleed air from the fuel filter element [C].
7. Repeat steps 4 to 6 until the air does not come out of the air
release plug [D].
8. Finally, firmly tighten the air vent plug [D] and priming pump [E] to
wipe the surrounding fuel clean.
A B
D
E
C
Summary of Contents for Maxi-Power MP65 T4F
